How to Properly Install the Cone Crusher's Crushing Wall
2025-01-08
A cone crusher is a commonly used mechanical device for breaking materials such as ores, limestone, and coal; one of its key components is the moving cone liner. Next, we will introduce Conical Crusher Crushing Wall The installation steps.
Conical Crusher Crushing Wall Installation steps:
1. Remove the protective oil layer from the spindle, spherical surfaces, and conical areas, ensuring that the lubrication oil holes and channels remain clean and unobstructed.
2. Apply a layer of yellow dry oil to the spindle surface, and evenly coat the spherical and conical surfaces with a thin film of oil.
3. Use a thin plastic film to wrap the spindle, preventing contamination during installation.
4. Place Conical Crusher Crushing Wall Place it on the steel frame, weld two symmetrical circular rings onto the outer surface of the moving cone wall, and then lift the moving cone liner into its designated position. Next, install the small bushing, spacer ring, and cap nut (making sure to use a left-hand thread), and tighten the cap nut securely using a specialized wrench and a heavy hammer. Finally, use a feeler gauge to check the gap between the assembly and the moving cone liner, ensuring that the clearance is nearly zero and evenly distributed around the circumference.
During the installation process, please Conical Crusher Crushing Wall Gently lift each component, ensuring the main shaft of the moving cone wall smoothly enters the sleeve of the vibrator assembly. This will allow the spherical surface of the moving cone liner to make proper contact with the spherical surface of the moving cone bearing, preventing the outer edge of the conical tongue ring from touching the moving cone bearing and avoiding damage to the sealing ring.
By following the correct installation process, it is possible to ensure Conical Crusher Crushing Wall The components can operate efficiently and reliably, extending the lifespan of the equipment.
Duma Machinery's main products include: mantle and concave liners, crushing walls, and distribution plates for cone crushers; jaw plates, side guards, and pressure bars for jaw crushers; lining plates for ball mills, autogenous mills, and other equipment; impact crusher hammers and impact plates; as well as hammer heads, screen bars, liner blocks, and other wear-resistant alloy steel components for metal shredders.